1. Loosen the nut on the stud
fitting and remove it
2. Place the nut over the swaged
end of the flexible hose
3. Place the pipe connector clamps
in the housings on the hose
4. Slide the nut forward to the end
of the flexible hose and assemble
onto the male thread
5. Tighten the nut using the
2" – 2 1/2" spanner set
Using a pipe to pipe connector
1. Loosen the nut on the
connector and remove it
2. Fit it over the swaged end
of the flexible hose
3. Place the pipe connector clamps
in the housings on the hose
4. Slide the nut forward to the end of the
flexible hose, until it touches the clamps
5. Tighten the nut using the
2" – 2 1/2" spanner set
Using a 90° elbow
1. Loosen the nut on the
elbow and remove it
2. Fit it over the swaged end
of the flexible hose
3. Place the elbow clamps in the
housings on the hose
4. Slide the nut forward to the end of the
flexible hose, until it touches the clamps
5. Tighten the nut using the
2" – 2 1/2" spanner set
TransairPipeSales.com is owned and operated by mdi, Manufacturers Distributor, Inc. mdi is an Authorized Parker Transair Piping System Distributor. Click Here to view the mdi Line Sheet.
This website stores cookies on your computer. These cookies are used to collect information about how you interact with our website. We use this information in order to improve and customize your browsing experience and for analytics and metrics about our visitors both on this website and other media. To find out more about the cookies we use, see our Privacy Policy.